After the first Insert-Nock, the first Out-Nock and the first InOut-Nock for target archery, Werner Beiter designed also the first PinOut-Nock! The inner diameter of the Beiter PinOut-Nock fits precisely on to the related pin and the shafts end preserves thanks to the bigger outer diameter. Each Nock size has only one single mould. This offers highest precision and lowest tolerances. Every single PinOut-Nock comes out of the same cavity. The Nock does not pinch on the nocking point, it rests there with a spring effect. The working life is much higher and, very important, the Beiter Nock guarantees constant release from the bowstring, shot after shot. The Beiter PinOut-Nock is available as asymmetric or symmetric (Hunter). To ensure that a Beiter Asymmetric Nock is placed correctly, control that the notch for the nocking point looks to the front of the arrow. The Beiter PinOut-Nock can be shot without problem with all known nocking points; but the Beiter nocking point is the ideal partner for any asymmetric Beiter Nock. The Beiter PinOut-Nock fits with its inner diameter on the related pin. It may happen that there is a gap between the outer diameter and the shaft! The Beiter PinOut-Nock is available only for selected pin-shaft-combinations, especially for arrow shafts which have no other Beiter Nock option than the pin. Beiter PinOut-Nocks are available for Pro-Tour Pins, X-10 Pins, ACE Pins, Nano-XR-Pro and Nano-XR Pins. The Beiter PinOut-Nock is available in the Beiter patented ASYMMETRIC version, as well as in the SYMMETRIC version, for Compound archers using a D-Loop.